# How many tectonic plates should my planet have? And why?

While constructing a planet, with the same mass, volume and overall composition as Earth, how do I know how many tectonic plates should it have? And what does having more or fewer tectonic plates change?

• Do keep in mind that the amount isn't too important - plates vary considerably in size. There's about 7-8 major plates on Earth, but the total amount is somewhere around 50-100. These also vary in time, as new plates are created and old plates are either subducted or acreted. I assume you're mainly concerned with just the largest plates like the Eurasian plate? – Luaan Jun 6 '18 at 10:38
• Related XKCD – Angew is no longer proud of SO Jun 6 '18 at 12:19
• 256. It is an 8 bit planet ;) – TomTom Jun 6 '18 at 13:21

Obviously there are lots of unknowns here, but you can make some good guesses just by reasoning through the details (kind of like how, even if you'd never seen a planet, you could work out that all planets have at least one cyclone, due to the hairy ball theorem).

• An Earth-like planet has a crust because its exterior is cool enough for magma to solidify

• But the crust is too fragile to be in one piece like an eggshell, because the stresses from tides and internal convection, summed over a whole sphere, are great enough to crack the shell

• Maybe the plates start as islands floating on a sea of magma, and then grow until they meet; or maybe the crust forms and then breaks; or some combination of the two. Regardless, for various reasons, I think it is valid to assume we start with an unbroken shell (1)

• Once a crack starts (2), it will tend to grow until it hits another crack (because the stresses are still there, and the tip of a crack is the weakest part of the shell)

• So if you start with a single crack, that crack will keep growing, in a random-ish path, at both ends (3)

• It is possible that the two ends will circle around and meet head-on, cutting the crust into exactly two plates (4). However, I think that's improbable enough to ignore.

• The next thing that will happen, then, is that one end of the crack will circle around and hit itself, so you have one complete plate plus one crack that is still growing (5).

• The growing crack will either stop at the edge of the first plate (6), or it will again intersect itself to make "spectacles" (7) – either way, you now have three plates.

• After that, any new crack that forms will eventually cut one of the existing plates in half, increasing the total number of plates by one.

So just from this topological reasoning, we can assume that your planet will have at least three plates. That's not nothing!

We also know that the larger a plate is, the more stress it experiences. Also, that relationship is non-linear (because of the nature of the forces involved combined with the square-cube law). That suggests two further ways to get more information.

1. When a plate is too big, it will crack in two. But the process is random, so in many cases it will crack into one very small piece and one piece that is still too big. You could analyse the statistics of this with a generic simulation. Of course, the exact definition of "too big" – and therefore the expected number of plates – depends on actual hard numbers.
But you could refine your guess about the minimum number of plates, because, if a single plate is too big, then there's a good chance that dividing it into three would give you two small plates and one plate that is still too big.

2. If you had a million plates, that would amount to a single giant volcano, and the lava would build up on the surface, making the crust thicker and stronger, so you'd get fewer plates. You could develop a sketch model of this equilibrium and try to estimate the upper limit on the number of plates for a planet with extreme tides.

If nothing else, I think I have convinced myself here that an Earth-like planet could be expected to have an Earth-like number of tectonic plates (perhaps 5-10 major ones).

As to what difference the number of plates makes, I would guess "not much" – a planet has whatever number of plates it needs to make those plates mostly stable. You might have more places like Chile, or more places like Chicago, but the nature of those places would be similar, and on an Earth-like planet you'd have some of each.

There may not be a formula for that, but if all the parameters are similar to earth, having a similar number of plates seems a reasonable guess.

More or less plates would mean more or less mountain ranges, fissures, and faults. Mountain ranges are formed as plates press against each other and the earth is heaved upward, fissures and trenches as one slides under the other. Faults are cracks on the plates formed by pressure - occasionally they shift...well, I'll let Superman explain...

it's the joining together of two land masses. The fault line is unstable and shifting, which is why you get earthquakes in California from time to time.

Less plates might also mean the geography of the planet might not change as much over time. Less plates mean less movement of the land masses.

• more plates might also lead to less force behind each plate so more frequent but less severe Earthquakes and not so high mountains/ not so deep trences – Daniel Jun 5 '18 at 14:33
• Also to consider: maybe it’s not just about what tectonic distribution is convenient but also what is reasonable. The formation of tectonic plates isn’t random; they were caused by the planet itself. Is it really feasible that, if the OP only wanted one mountain range, only two tectonic plates would form? – gen-ℤ ready to perish Jun 5 '18 at 17:43
• I think the question is more, what about the planet would have to be different for less or more plates to form. A cooler mantle of the planet might result in less/larger plates, as less pressure from the currents of flowing magma pulling and pushing against the crust. – VBartilucci Jun 5 '18 at 18:06
• Now, can you get Superman to explain how flying in a circle around the Earth, backwards, causes time travel? – Ghotir Jun 5 '18 at 19:58
• No, that reverses time, if you want travel back in time properly you need to fly around the sun, just ask Star Trek – ArcWraith Jun 6 '18 at 7:05

First, since you are comparing this planet to Earth, having the same mass, volume and composition, it helps to know what earths tectonic plates look like.

Earth has seven major plates and ten minor plates, as well as many micro-plates. To answer your second question, what does having more or fewer plate tectonics change?, it would mainly change what your planet looks like. These tectonic plates create volcanoes and mountains, depending on how the plates are merging. This means that along plate boundaries, there are usually either islands in the oceanic places and mountains along the inland areas (this is all dependent on the tectonic plate interactions, which I talk about below).

Other than how violent your planet is, a significant reason for our atmosphere is from these plates with volcanoes spewing carbon into the atmosphere. Having more plates and thus more plate tectonics would likely result in a more robust atmosphere. Or, at least, it would take less time for your planet to have a habitable atmosphere, and likely produce life quicker than Earth.

How many plates you should have is totally up to you. However, I would recommend you at least have a couple if you want your new planet to be similar to earth.

More the more important question, in my opinion, than how many plates, is what TYPE of tectonic plate interactions you want. These interactions will dictate whether you have transform boundaries that produce earthquakes, divergent boundaries that produce volcanoes, or convergent boundaries that produce mountains.

• Does having more plates directly transfer to having more tectonic activity? I´d recon it depend on what drives the plates, i.e. how much of each plate is consumed in a given amount of time and how much local pressure builds up. If the plate gets too small, it could be conceivable that pressure-maxima and minima regulate internally, without erupting. – Daniel Jun 5 '18 at 14:38
• I didn't even think of that, thanks for bringing that up. You are right, the activity is driven by convection of molten rock to shift the mantle. If the plates are too small I could image that there wouldn't be enough force to move them. – cjnash Jun 5 '18 at 14:55
• I´d imagine lots and more distributed small earthquakes, but basically it´s a chaotic system so hard to predict. Would be funny to imagine what would happen when a small plate would actually topple over or stack, like shelf-ice. – Daniel Jun 5 '18 at 14:57
• Note that the number of plates can change over time. They aren't fixed by any means. Plates can weld together, split, or be subsumed. Also note that sometimes where they are bounded can be vague; the Chersky Range in Siberia is the contact between the North American and Eurasian plates, but what's going on there isn't clear. – Keith Morrison Jun 5 '18 at 15:58
• Note that Mars, which has much less internal heat, only has two plates for the entire planet, so it's a probably a good assumption that more heat = more plates. – Skyler Jun 5 '18 at 16:35

Roughly speaking, because I started to write "a deep time approach to worldbuilding" outlining my preferred technique then realised I'd be here all week, decide how many continents you want to have, on Earth there are 7 and how many active mountain ranges you want in the continental interiors, on Earth we have 2, the Himalaya, and the Southern Alps (most of the "continent" around New Zealand under the South Pacific but it's there).

The total is roughly how many major plates you need, Earth has 7 major and 6 minor plates; active mountain ranges, like the Alps (both European and Southern), Andes, Cascades, Himalaya, Japan and the Sierras mark plate boundaries as do major ocean basins, the Mid Atlantic Ridge, East Pacific Rise, Southern Ocean spreading ring. How these boundaries migrate and change over deep time is governed by plate tectonics which we still don't understand all the driving forces of yet but we do have a good working model of.

The different plate boundaries give rise to different characteristics at the margins of the continents that they hold, active margins are highly geographically dynamic and occur at convergent boundaries like subduction zones and along transforms like the Alpine Fault. They're characterised by elevated terrain, regular seismic activity, volcanism, mountain building and high average erosion rates. Passive margins occur at continental edges proximate to divergent boundaries, here river mouth deposition and coastal erosion are the primary forces in landscape dynamism and the pace of change is much slower. Passive margins are characterised by gently sloped or rolling terrain, slow meandering rivers often with wide deltas, salt marsh, barrier islands and low average erosion rates.

Having more plates means the continents are smaller, there are more coasts, more active boundaries. This means more nutrient turn over due to higher overall average erosion rates, and richer oceans, more shallow water for reefs more coastal wetlands for fish nurseries, less farming land but of a higher quality where it does occur due to higher erosive nutrient input rates.

Fewer plates means larger continents, fewer coasts less, active boundaries, a lower overall nutrient turnover from erosive processes so farmland is poorer but there's more of it. The issue that could be really critical is that evidence from the late Permian suggests that if there aren't enough separate continental landmasses ocean circulation is greatly impeded and this can kill sea-life.

Elaborations of any unclear points are available on request, let me know what you want me to focus on and I'll edit accordingly.

One thing I should have made clear and I don't think I have is that only the areas of plates with continental crust are anything like stable over geological time, we call those areas cratons, oceanic crust is always being created at rifts and consumed at subduction zones. That's what creates supercontinents and drives up mountains.

• "Having more plates means the continents are smaller" - That's not necessarily true. Consider Asia: 1 continent, right? There's three plates: Eurasian, Indian, and North American. Four if you count the area around the Arabian Peninsula. Continents, in geological terms, tend to be associated with individual plates, but that isn't necessarily the case as multiple plates can also forms a single landmass deemed to be a continent. – Keith Morrison Jun 6 '18 at 17:11
• @KeithMorrison A. Asia is two continents, Asia Minor being made up of and constituting the Indian "micro" plate. B. the North American plate does not act as a separate entity from the Eurasian Plate in the modern tectonic environment. More plates means more boundaries, those boundaries will tend to delineate separate continents, not always but there will still be proportionally more separate, smaller, continents if there are more plates. – Ash Jun 6 '18 at 17:27

This is somewhat circumstantial, because I am not an expert on plate tectonics. But I do work with quite a few people who are experts on that topic, and I have asked them in the past the question "why does Earth have the number of tectonic plates that it does?" Their answer was a very strong "we don't know."

Moreover, we don't know what parameters it depends on. People would like to know this, because it would allow us to predict whether there will be plate tectonics on exoplanets, and if so what form it will take. There are many competing theories about how plate tectonics gets started (and why it happened on Earth but not on Venus), but unfortunately it just isn't something that science has a good understanding of yet. We can understand how the Earth's plates move and why, but we can't understand how the process gets started and what it might be like on other planets. This is partly because so far we only have one example of a planet with tectonic plates.

Therefore an honest answer to your first question should probably also be "we don't know."

On the positive side, this means you're pretty much free to choose whatever number of plates you like, and it will be consistent with modern scientific knowledge :)

A few other back-story factors will impact your answer, but again, they'll be largely within your control.

As best we know, the engine behind plate tectonics is convection in the Earth's mantle. As a quick demonstration, sprinkle a dime-thick layer of wheat germ over a pot of slowly boiling water (or for more cogent illustration, slowly boiling molasses). The planetary case is affected by some very large departures from this simple case...

1) Your planet may not even have a fluid, semi-fluid, or plastic mantle. (Subsequent questions assume you've got a little something to work with.) 2) A spherical planet surface complicates the geometry of upwellings and subduction zones. 3) Planetary rotation will affect both this geometry and the distribution of heat transfer to and from the mantle. 4) Chemical composition of the mantle and heat transfer from the planetary core will affect the violence of convection within the mantle. (Compare the pots of water and molasses, and then turn up the heat under the molasses to see how more violent convection tends to result in a greater number of smaller plates.)

If you're free to ignore or freely specify the history of your solar or planetary system, none of this will have any significance. Even if cosmological history has an important impact on your story, you can easily take it into reasonable account and still have a lot of wiggle room.